DS/EN 1751:2014 Ventilation for bygninger
Bøger og forlag Ikke på lager

DS/EN 1751:2014 Ventilation for bygninger

Ventilation i bygninger - Dele til luftfordelingssystemer - Aerodynamisk prøvning af spjæld og ventiler. Denne europæiske standard angiver metoder til testing og fastlæggelse af spjæld og afspærringsventiler anvendt i luftfordelingssystemer med en trykdifference på op til 2000 Pa.

Udgiver: Dansk Standard
Udgivelsesår: 2014
Sider: 36
Sprog: Engelsk

Varenummer: dsen1751

Tema
Bog
582,75
728,43 inkl. moms

Ikke på lager. Forvent en leveringstid på ca. 4-7 dage

Ventilation i bygninger - Dele til luftfordelingssystemer - Aerodynamisk prøvning af spjæld og ventiler.

Denne europæiske standard angiver metoder til testing og fastlæggelse af spjæld og afspærringsventiler anvendt i luftfordelingssystemer med en trykdifference på op til 2000 Pa.


Testmetoderne omfatter:
- Udsivning forbi et lukket spjæld eller ventil
- Lækage
- Flow/tryk
- Drejningsmoment
- Varmetransmissionskoefficient

This European Standard specifies methods for the testing and rating of dampers and valves used in air distribution systems with pressure differences up to 2 000 Pa. The tests incorporated in this European Standard are: a) leakage past a closed damper or valve (for classification see Annex C); b) casing leakage (for classification see Annex C); c) flow rate/pressure requirement characteristics; d) torque: (see Annex A); e) thermal transmittance: (see Annex B). The acoustic testing of dampers and valves is not included in this European Standard. The tests specified above apply to the following: f) measurement of leakage past a closed damper or valve; g) measurement of casing leakage; h) determination of flow rate and pressure requirements; i) measurement of torque characteristics (see Annex A); j) measurement of thermal transfer characteristics to determine insulation properties (see Annex B). NOTE Certain aspects of the dynamic performance of dampers or valves are dependent upon the air distribution system to which they are connected and are, therefore, difficult to measure in isolation. Such considerations have led to the omission of these aspects of the dynamic performance measurements from this European Standard. Also, in common with other air distribution components, the results from tests carried out in accordance with this European Standard may not be directly applicable if the damper or valve is situated in an area of non-uniform flow.